77 viewsThe outboard well cover and plug. This gives quick access in the event of a fouled prop. No need to go over the side or take the boat out of the water.
77 viewsThe picture shows a valve in postition at the end of the outboard well moulded rim on the starboard side
76 viewsThe plywood supports that clip over the transom and compensate for its 18 degree slope (keeps the support frame upright)
74 viewsPort side access
73 viewsRemoval of the single thumb screw on the step gives quick access to the front of the engine
73 viewsThe base is the full width of the cockpit and fits at the back of the transom behind the cockpit drain scuttles. I have cut a section out at the bottom to allow for my outboard well plug and cover (see inboard engine installation photos
72 viewsAt its mooring. Note position of engine controls
71 viewsCockpit engine cover moulding
62 viewsEngine controls in side coaming. This keeps them well clear of ropes in the cockpit
Most viewed - David Peck's Gallery
Home
Login
Return to Forum
Album list
Last uploads
Last comments
Top rated
My Favorites
Search
