 Last additions - David Peck's Gallery
|
101 viewsThe complete mast riggedFeb 20, 2015
|
|
119 viewsPort hand side - note release ring is held to the top via angled shackleFeb 11, 2015
|
|
115 viewsClosing the pelican hook and beginning to tension the bobstayFeb 11, 2015
|
|
111 viewsPelican hook in open positionFeb 11, 2015
|
|
118 viewsBobstay system in set position under tensionFeb 11, 2015
|
|
101 viewsMast and boom supported with transport cover fittedFeb 11, 2015
|
|
73 viewsThe base is the full width of the cockpit and fits at the back of the transom behind the cockpit drain scuttles. I have cut a section out at the bottom to allow for my outboard well plug and cover (see inboard engine installation photosFeb 11, 2015
|
|
76 viewsThe plywood supports that clip over the transom and compensate for its 18 degree slope (keeps the support frame upright)Feb 11, 2015
|
|
87 viewsThe simple frame that sits in the bottom of the outboard well and clips over the transom. The triangular plywood section inverts to support a pole for a full winter coverFeb 11, 2015
|
|
131 viewsThe mast/boom/gaff support in place for transport. The tiller can still be operated when lowering the mast for bridges etc.Feb 11, 2015
|
|
77 viewsThe picture shows a valve in postition at the end of the outboard well moulded rim on the starboard sideFeb 11, 2015
|
|
47 viewsThis shows the one way flap valveFeb 11, 2015
|
|
37 viewsPort and starboard completed implant valvesFeb 11, 2015
|
|
39 viewsThe silicon mould and two completed insertsFeb 11, 2015
|
|
109 viewsBottom end of outboard well plug. With the folding propeller this gives good sailing performanceFeb 11, 2015
|
|
|
|
Home
Login
Return to Forum
Album list
Last comments
Most viewed
Top rated
My Favorites
Search