furler

The prime movers for your Cape Cutter 19.....

Re: furler

Postby erbster » Wed Jul 22, 2020 12:07 am

oak wrote:malcolm,
I didn't even attempt to get a prlacement pin for the Ronstan as I am not sure of the thread.Its on there website in Imperial measurements .
I drilled out the fitting and used a 8mm ss clevis pin with ring .Cheap and cheerful
works a treat
Oak
Pragmatic solution!


Cape Cutter #86 Aurora
travellingaurora.wordpress.com
Charles Erb
CC86 Aurora
travellingaurora.wordpress.com
erbster
Honorary President
 
Posts: 610
Joined: Fri Apr 06, 2012 7:57 pm
Location: Midlands

Re: furler

Postby oak » Wed Jul 22, 2020 9:48 am

Final thought .
The current online illustration of the Ronstan furler shows it attached with a clevis pin.
Oak
oak
CC19 Association Member
 
Posts: 154
Joined: Mon Apr 06, 2009 9:15 pm
Location: ireland

Re: furler

Postby Malcolm Sadler » Wed Aug 05, 2020 5:19 pm

Thanks for the very sensible suggestion of enlarging the hole. Unfortunately before I read that the UK supplier had surfaced, quoted me two arms and a leg for 4 pins and rings and I ordered them. So I can lose 3 more over the side before reaching for my drill.

Malcolm
Malcolm Sadler
CC19 Association Member
 
Posts: 138
Joined: Sat Oct 10, 2015 9:58 am

Previous

Return to Hull, Rigging and Sails

Who is online

Users browsing this forum: No registered users and 2 guests